Hi, Guido,

When I finished the update the original DISKO 1.1.1 to 1.5, and also upgrade MorphineTV, when run, it occurs a "Segmentation fault", even no any output message via "printf". Any lead to debug this phenomena? The original combination of release is ok on my CX24500 platform.

Best regards,
Alan

Hello alanz,

did you compiled disko with debug output? If not do

Code:

scons graphics=x11 debug=yes messages=yes

and then as root

Code:

scons install

After this, you have to rebuild morphine.tv, too. Regards, René

Hi, Rene,

I am afraid that it cannot not be so easy. Right now, I ported 1.5.0 onto 2 platform, one is CX24500, and the other is PNX8935. The execution failure is almost the same. If I switch back to former release 1.1.1, both platforms work. I use DirectFB not X11, and I do not use SCON build tool, just directly work with the Makefiles contained. The code comparison result indicates that there exist a large modification between 1.1.1 and 1.5.0. So I cannot get any leads about this failure.

Best regards,
Alan

Hi Alan,

you can try building with debug symbols anyway, by using make debug=y.
If you can send us the corefile afterwards, we may get a glue, what's
going on.

Regards,
Matthias